Zoom the image with the mouse
Permatex High Strength Threadlocker Red - 6ml
SKU:
198622
UPC:
686226271006
$8.99
Permatex High-Strength Threadlocker Red is ideal for heavy-duty applications 3/8" to 1" (10mm to 25mm) Red threadlocker is well-suited for permanently locking studs and press fits. Threadlocker RED adds 3,000 PSI holding power on slip and press fit assemblies, and replaces set screws and snap rings. Permatex’s Threadlocker Red locks against vibration loosening. May require heat or special tools for removal.
Suggested Applications
Cylinder block and rocker arm studs, ring gear bolts, frame bolts, and shock absorber bolts.
Instructions
Directions
- Clean and dry parts using Permatex Surface Prep activator, Item# 24163
- Shake tube of High Strength Threadlocker well before each use
- Remove cap and snip nozzle tip
- Apply to threaded areas and assemble parts. Refer to Technical Data Sheet for complete information
Note
Threadlocker works on metal parts. It is not recommended for plastics. Cured product must be heated
to 500°F (260°C) before parts will separate.
Specifications
- Size: 6ml
WARNING: This product can expose you to chemicals including Methyl methacrylate, Cumene hydroperoxide, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
Permatex High-Strength Threadlocker Red is ideal for heavy-duty applications 3/8" to 1" (10mm to 25mm) Red threadlocker is well-suited for permanently locking studs and press fits. Threadlocker RED adds 3,000 PSI holding power on slip and press fit assemblies, and replaces set screws and snap rings. Permatex’s Threadlocker Red locks against vibration loosening. May require heat or special tools for removal.
Suggested Applications
Cylinder block and rocker arm studs, ring gear bolts, frame bolts, and shock absorber bolts.
Instructions
Directions
- Clean and dry parts using Permatex Surface Prep activator, Item# 24163
- Shake tube of High Strength Threadlocker well before each use
- Remove cap and snip nozzle tip
- Apply to threaded areas and assemble parts. Refer to Technical Data Sheet for complete information
Note
Threadlocker works on metal parts. It is not recommended for plastics. Cured product must be heated
to 500°F (260°C) before parts will separate.
Specifications
- Size: 6ml
WARNING: This product can expose you to chemicals including Methyl methacrylate, Cumene hydroperoxide, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
