![Simple Green Industrial Cleaner & Degreaser - 1 gal Simple Green Industrial Cleaner & Degreaser - 1 gal](https://cdn11.bigcommerce.com/s-qz13ep5fb4/images/stencil/290x290/products/167612/248490/195859__99927.1691573653.jpg?c=1)
![Simple Green Industrial Cleaner & Degreaser - 1 gal Simple Green Industrial Cleaner & Degreaser - 1 gal](https://cdn11.bigcommerce.com/s-qz13ep5fb4/images/stencil/290x290/products/167612/248491/195859_1__91141.1691573653.jpg?c=1)
Protect and preserve below-ground exterior wood with Rust-Oleum Wolman Woodlife CopperCoat green wood preservative. This unique formula contains an insecticide and nearly double the fungicide of standard sealers or Stains. It paintable and stainable. It can be used alone or before painting or staining below-ground, ground-contact, fresh-water contact and above-ground wood.
Pre-treatment by dip method before installation is recommended. Also designed for protection of deck or porch floor end cuts.
If wood is brand new and intended for outdoor installation and exposed to weather conditions for 30 days or less, a "splash test" should be performed to determine if there is any surface barrier present which would repel a new coating. Sprinkle a few drops of water on several areas of the surface to be coated. If the water is absorbed rapidly, the surface is ready to be finished with Woodlife CopperCoat. If the water beads are not absorbed into the wood, a surface barrier exists and must be removed. Apply or Wolman deck & fence brightener and then test again. Regardless of the surface's age or condition, failure to follow proper preparation methods will result in poor adhesion and/or possible coating failure.
Protect and preserve below-ground exterior wood with Rust-Oleum Wolman Woodlife CopperCoat green wood preservative. This unique formula contains an insecticide and nearly double the fungicide of standard sealers or Stains. It paintable and stainable. It can be used alone or before painting or staining below-ground, ground-contact, fresh-water contact and above-ground wood.
Pre-treatment by dip method before installation is recommended. Also designed for protection of deck or porch floor end cuts.
If wood is brand new and intended for outdoor installation and exposed to weather conditions for 30 days or less, a "splash test" should be performed to determine if there is any surface barrier present which would repel a new coating. Sprinkle a few drops of water on several areas of the surface to be coated. If the water is absorbed rapidly, the surface is ready to be finished with Woodlife CopperCoat. If the water beads are not absorbed into the wood, a surface barrier exists and must be removed. Apply or Wolman deck & fence brightener and then test again. Regardless of the surface's age or condition, failure to follow proper preparation methods will result in poor adhesion and/or possible coating failure.